Expansion Cards     ES01

■ Control your computer from anywhere in the room using 2.4GHz RF remote

■ 2.4GHz receiver PCI or PCI-E card included

■ Works as far away as twenty meter

■ Includes power / reset switch Y cable

■ Includes optional low profile expansion slot cover

         ES01 is a convenient remote switch kit designed by SilverStone to wirelessly turn on/off and reset a computer. By utilizing existing standard 2.4GHz RF wireless technology, PCI or PCI Express x1 slot, and power/reset pin headers on a motherboard, the ES01 kit is easy to install and use within 20 meters of a connected computer. An included Y cable ensures your computer case’s own power and reset buttons can be used concurrently with the ES01 if needed. Users looking for a simpler security solution than software access control will find ES01 to be a good alternative. Those with computers located in hard to reach area or has special usage scenarios will also find the ES01 to be very handy.


Model No. SST-ES01-PCIe / SST-ES01-PCI
Adapter card
Adapter form factor Low profile PCI-E x1 / Low profile PCI x1
Bracket Standard x 1 and Low profile x 1
Operation frequency 2.4GHz
EIRP 3.76dBm (Measured max.)
Operating range 20 meter (Free space)
Environment Operating temperature : 0℃~40℃ (32℉~104℉)
Storage temperature : -40℃~70℃ (-40℉~158℉)
Operating humidity : 10%~90% non-condensing
Storage humidity : 5%~90% non-condensing
Remote control
Operation frequency 2.4GHz
EIRP 3.76dBm (Measured max)
Operating range 20 meter (Free space)
Battery type CR2025 (Lithium manganese button battery)
Nominal voltage DC 3.0V
Battery environment Operating temperature : -20℃~70℃ (-4℉~158℉)
Storage temperature : 10℃~40℃(50℉~104℉)

2.4GHz wireless computer power and reset remote switch more...
ES01 manual
1,518 KB
ES01 High resolution photos
2,830 KB

ES01 eDM (es01-edm-en.pdf)
204 KB


Please check if the LED indicator blinks when pressing the Power or Reset button, if it doesn’t blink, then you should change the battery.
If it blinks, but still can’t turn on the computer, please try the following steps:
(1) Unplug the computer’s power cord, pull and insert the card several times and check if the expansion slot is dirty. Use an eraser to clean the gold fingers (connector’s metal pins), then re-insert the card.
(2) Check if the POWER SW and RESET SW are connected in the correct position, be sure they are not loose.
If these steps do not work, then check in motherboard’s BIOS/UEFI menu to make sure PCI-E functions have been enabled.

A:Solution: Re-sync the switch and the card.
How to: Long press the Power button and Reset button at the same time, until the indicator light flashes five times.